System Monitoring; General; Starting For The First Time Via The Fronius Solar.web App - Fronius Primo 3.8-1 208-240 Instructions De Service

System monitoring

General

If no device special version is present, the inverter is equipped with Wi-Fi enabled system
monitoring Fronius Data Manager 2.0.
The monitoring system includes inter alia the following functions:
-
-
-
-
-
-
-
-
-
-
Further information about the Fronius Data Manager 2.0 can be found online in the Fronius
Data Manager 2.0 operating instructions.
Starting for the
First Time via the
Fronius So-
lar.web App
To start Fronius Datamanager 2.0 for the first time,
-
-
IMPORTANT! To establish a connection to Fronius Datamanager 2.0, the end device in
question (e.g., laptop, tablet) must be configured as follows:
-
1
16
own website with display of actual data and a wide variety of settings
direct connection-possibility to Fronius Solar.web
automatic sending of service messages via SMS or e-mail in case of errors
Internet connection via WiFi or LAN
Possibility to control the inverter by setting of power limits, minimum or maximum op-
erational times or target operational times
Controlling the inverter via Modbus (tcp / rtu)
Allocation of control priorities
Controlling the inverter by connected meters (Fronius Smart Meter or S0 meter)
Controlling the inverter via a ripple control signal receiver (eg reactive power setting
or power setting)
dynamic power reduction considering the own consumption
NOTE! The Fronius Solar.web App makes starting Fronius Datamanager 2.0 for
the first time significantly easier.
The Fronius Solar.web App is available in the relevant app store.
the Fronius Datamanager 2.0 plug-in card must be installed in the inverter,
or
there must be a Fronius Datamanager Box 2.0 in the Fronius Solar Net ring.
"Obtain an IP address automatically (DHCP)" must be activated
WARNING! An electric shock can be fatal. Danger from grid voltage and DC volt-
age from solar modules.
Before opening the inverter:
- You must wait until the capacitors have discharged.
- Follow the operating instructions when opening the inverter.
- Observe the safety rules and safety instructions contained in the inverter's
operating instructions.
Connect the inverters with Fronius Datamanager 2.0 or Fronius Datamanager Box 2.0
in Fronius Solar Net
IMPORTANT! Inverters Fronius IG, Fronius IG Plus, Fronius IG Plus V, Fronius IG
Plus A, Fronius CL, Fronius CL USA, and Fronius IG 300–500 must always be located
at the beginning or end of the Fronius Solar Net ring.