Publicité
Les langues disponibles
Les langues disponibles
Warning:
Always keep your hands well clear of the rotating bit.
Do not remove chips and workpiece parts until the machine is
at a standstill.
Always close the chuck guard and pulley cover before you
start the machine.
When using a drill press vice, always fasten it to the table.
Never do any works "freehand" (hand-holding the work piece
rather than supporting it on the table), except when polishing.
Support long workpieces with helping roller stands.
Do not use wire wheels, router bits, shaper cutters, circle
cutters, or rotary planers on this drill press.
Never cut magnesium-
high danger of fire!
7. Setup and adjustments
General note:
Setup and adjustment work may only be carried out after
the machine is protected against accidental starting by
pulling the mains plug.
7.1 Removing the Chuck and Arbour
Unplug the machine from the power source.
Lower the quill using the down feed handle.
Rotate the spindle to align the key in the spindle with the key
hole in the quill.
Insert the drift key into the aligned slots and tap lightly. Have
another person (or a protected table) catch the chuck and
arbour assembly as it falls away from the spindle.
7.2 Adjusting the Depth Stop
To drill multiple holes at the same preset depth, use the
depth stop (K, Fig 7).
With the drill bit in the chuck, lower the down feed handle to
advance the drill bit to the work piece.
Lock the depth stop to the desired cutting depth.
378VB
The drill bit will now advance only to this point.
7.3 Changing Spindle Speeds
Unplug the machine from the power source.
Loosen the locking screw (W, Fig 8) on the pulley cover, then
open the cover.
Loosen the motor lock knob (U) found on the rear of the head
assembly.
Release the belt with the tension lever (B).
Change the belt location according the speed chart and the
speed you desire (Fig 9).
8
Fig 7
Fig 8
Fig 9
Publicité
