Publicité
HARDWARE USED
Item H-4
Item H-3
Item H-6
Item H-11
Item H-10
Item H-8
Item H-12
Fit spacer (H-4) into pawl (P-8). Then continue to
1.
assemble using bolt (H-3), support brackets (P-7)
and nut (H-11) as shown.
IMPORTANT! Test fit bolts into holes of backboard brackets and
2.
carefully rock them in a circular motion to ream out paint from holes if
necessary. Flip pawl (P-8) back to allow easier access to assembly
area. Attach lower elevator tubes (P-9) to backboard brackets using
spacers (H-7, H-10 & H-12), bolts (H-6), ratchets (P-10), and nuts (H-8)
as shown.
Item H-7
IMPORTANT!:
DO NOT TIGHTEN
HARDWARE
COMPLETELY.
H-3
P-8
H-6
7
Item included with
board hardware
H-11
P-7
P-7
H-4
IMPORTANT!:
DO NOT TIGHTEN
HARDWARE
COMPLETELY.
H-12
H-7
H-10
H-7
P-10
H-10
P-9
11/04
P-8
H-8
P-9
P/N 21412507
Publicité
