Publicité
SECTION A: ASSEMBLE THE ELEVATOR TUBES TO A
This is what your system will look like
when you've finished this section:
To ensure optimal playability of backboard system, a close tolerance fit between the elevator
components and hardware is required. Test-fit large bolts into large holes of elevator tubes,
backboard brackets, and triangle plates. Carefully rock them in a circular motion to ream out
P/N 21412507 11/04
STEEL-FRAMED ACRYLIC BACKBOARD
BEFORE YOU START!
any excess paint from holes if necessary.
*NOTE: Not all parts shown are inclused with every system.
Identify elevator tubes (P-9).
Toward
Board
Item not included.
Included with
board hardware
6
Toward
P-9
Mount
Publicité
