Publicité
3.
Hold angled brackets (P-4 and P-5) on roof and keep u-channel (P-2) upright. Measure from top of playing
surface to upper elevator hole in u-channel. Distance should be 106-3/4"" (2.71 m).
A.
To achieve 106-3/4" (2.7 m) you may
have to make some adjustments.
Such as turning the tube over on the
opposite end, and/or moving angled
brackets backward or adding height
to the entire assembly with wood
between angled brackets and roof.
Mark angled bracket locations on roof.
Angled brackets (P-4 and P-5) should be
parallel to each other before the bend and be
3-1/2" (8.9 cm) apart.
P-4
3-1/2" (8.9 cm)
Drill holes in roof. Position angled brackets and secure
4.
to roof.
A.
P-3
P-2
P/N 21412507 11/04
NOTE:
P-2
P-5
WARNING!
All mounting points should
be sealed to prevent leaks
and water damage"
106-3/4"
(2.71 m)
Keep u-channel (P-2) upright and
5.
position struts (P-3) on desired
location on roof approx. 26"-30" (66-
A.
76 cm) apart. Level tube in all
directions. Mark and drill holes.
Secure struts in place.
P-2
18
WARNING!
TWO PEOPLE
REQUIRED FOR THIS
PROCEDURE.
FAILURE TO FOLLOW
P-2
THIS WARNING
COULD RESULT IN
SERIOUS INJURY
AND/OR PROPERTY
DAMAGE.
•
Minimum distance
should be 106-3/4"
(2.71 m) from top
elevator hole to
playing surface.
Homeowner must
assume all
responsiblilty for any
personal or property
damage if
backboard height is
lower than
recommended.
P-3
Publicité
