Conrad Electronic WS222 Notice D'emploi page 74

14. Handling
Observe all safety instructions included in these operating instructions!
a) General
The product may not be opened or disassembled (apart from the battery replacement described in
these operating instructions).
None of the components inside the product is to be maintained by the user. Moreover, the licence
(CE) and warranty will lapse in such cases.
Do not drop the product, it will be damaged even if it falls down from a low height.
b) Base Station
Avoid the following unfavourable ambient conditions during the operation of the base station:
- damp or air humidity which is too high
- extreme cold or heat
- direct sunlight
- dust or combustible gases, vapours or solvents
- strong vibrations
- strong magnetic fields such as those found in the vicinity of machinery or loudspeakers.
Do not use the product immediately after it has been taken from a cold environment to a warm one.
The condensation water produced may destroy the product.
Wait until the base station has reached room temperature. This may take several hours!
Select such a place of installation that the base station stands safely and cannot fall down. There is
risk of injury due to its weight.
You should protect scratch-sensitive or valuable furniture surfaces by means of suited supports
before setting up the base station.
c) Multipurpose Sensor
Although the multipurpose sensor is protected against rain coming from above, it is not protected
against water from the sides or below. Therefore, never splash the station, e.g. by means of a garden
hose or another irrigation system.
Select such a place of installation that children can not tilt the multipurpose sensor. Do not set it up
in the proximity of vehicles, glass doors/windows or similar objects!
74