Publicité
Les langues disponibles
Les langues disponibles
Proceed as follows for mounting:
1. Own individual installation mast
• Screw out the two small screws at the bottom of
the multipurpose sensor a little bit.
• Insert the supplied mounting rod of 25cm from
into the multipurpose sensor the bottom in such
a way that the two holes in the mounting rod are
directly positioned under the screws.
• Then tighten the two screws carefully (screws
are to be screwed into the holes of the mounting
rod).
• The mast required must have a diameter of
between 25mm and 45mm. It can either be a free
mast or a mounting angle, e.g. for a satellite
dish.
• Position the shaped aluminium part on one side
of this mast/mounting angle and put a hose band
clip over the two parts.
• Set the short mounting rod of the sensor against the other side of the shaped aluminium part (on
the right side in Figure 2 above) and tighten the hose band clip by using a screwdriver.
2. Optionally available installation mast (not included in the scope of delivery)
If you want to drive the rod with the flat tip (serves as an earth tip) into the ground by means
of a hammer, use a suited wooden clump in any case to protect the mast. Otherwise, the
upper end of the rod will be damaged (installation of the sensor mast will not be possible
any longer), guarantee will lapse!
• Assemble the single parts of the sensor mast. Plastic couplers combine the individual rods.
• The flat rod end serves as an earth tip.
52
supplied
mounting rod
supplied shaped
aluminium part
mounting clip
installation mast
plastic coupler
Fig. 2b
Fig. 2a
Publicité
