Sentiotec Pro-B2 Instructions De Montage Et Mode D'emploi page 30

Instructions for use for the user
9.7. Cancelling the preset time function
● Press and hold down the preset time button
to cancel the preset time function.
► The preset time countdown is cancelled.
► Then the current temperature in the sauna room is displayed in the
temperature display
is displayed.
The most recently selected preset time is saved, which means the last
value can be recalled at the touch of a button. To reset the preset time
to 00:00, press the preset time button for three seconds.
9.8. Activating standby for remote operation
EN 60335-2-53 specifies that sauna control units with a remote start function
must be set manually to "Standby for remote operation" mode. This activation
must take place again after each remote start and stop procedure. To do so,
perform the following steps:
1. Press the temperature selector
► The remote start indicator 8 starts flashing.
► The sauna control unit is then ready to be started and stopped using
a remote start signal.
► After a remote start and stop, the remote start indicator goes out and the
mode has to be activated again.
9.9. Switching off the sauna control unit
1. Press the temperature selector
► The sauna heater is switched off
2. Press the ON/OFF switch
► The temperature display
► The sauna control unit is switched off.
. In single-sensor mode, the preset temperature
3
for three seconds(longpress).
2
.
2
, to switch off the sauna control unit.
5
goes out.
3
for three seconds (longpress)
6
p. 26/30