Sentiotec Pro-B2 Instructions De Montage Et Mode D'emploi page 2

Additional sheet for instructions for use
Activate door sensor at Pro B3
1. Open the technician menu (press at the same time: ON/OFF button, preset time button and the lower
bottom knob)
► In the top display „dry" appears
► In the bottom display „t60" appears
2. Turn the lower buttom (Selection 0 - 60; 0 = post-drying progamm off , 60 = maximum runtime in minutes)
3. Press the lower knob
► In the top display „SdO" appears
► In the bottom display „SAFE" appears (= standard setting)
4. Turn the lower knob to the right
► In the lower display "door" appears
5. Exiting the technician menu (Longpress on the lower knob)
10. Operation
Activating „Standby for remote operation" with door sensor
Press the ON/OFF switch, to switch on the sauna control unit.
Press the lower knob (= Temperature selector) for three seconds (=Longpress)
► A countdown of 30 seconds is shown in the lower display. During this time, the door can be opened/
closed as often as you like. After the countdown has expired, the door must be closed!
► The remote start indicator starts flashing.
► The sauna control is now ready to be started and stopped once via a remote start signal = Mode
„Standby for remote operation"
EN
Door is opened - warning „door" appears in the display
- at mode „Standby for remote operation":
To continue the mode, the door must be closed and the warning must be acknowledged with a long press
on the lower rotary control. ► The countdown (30 sec.) is shown again in the lower display.
- in operation or enable remot start output (for coinoperated unit or door sensor system):
The acknowledgment takes place automatically when the door is closed.
p. 2/2