SodaStream E-TERRA Mode D'emploi page 19

SET UP
SODASTREAM® CO
Please note that the
SodaStream® E-TERRA
/MD
only compatible with the CO
Quick Connect Cylinder and
is NOT compatible with the
SodaStream® CO Screw
2
System Cylinder or other
cylinders.
CONNECTING THE
POWER ADAPTER
Connect the pronged plug that fits your local outlet
to the power adapter. Check the power cord
placement at the base of the machine. Look for the
plug-in icon to insert the plug. Make sure that the
power cord is threaded through the slot.
INSTALLING THE CO
QUICK CONNECT CYLINDER
1. Place the SodaStream® E-TERRA
Maker on a flat sturdy surface and remove the back
cover.
2. Remove seal and cap from the SodaStream® CO
Quick Connect Cylinder.
WARNING! Never insert or replace the CO
Connect Cylinder while a Plastic Carbonating
Bottle is installed in the Sparkling Water Maker.
This can cause the Plastic Carbonating Bottle to be
ejected or burst.
3. Raise pink cylinder handle. Insert the CO
Connect Cylinder in the back of the Sparkling Water
Maker.
4. Lower the Pink Cylinder Handle..
5. Reinstall the back cover. Now you are ready to
create the bubbles.
6. Insert the plug into the wall outlet. The buttons will
light up. Only use an original SodaStream power
adapter.
QUICK CONNECT CYLINDER
2
COMPATIBLE SODASTREAM®
CO QUICK CONNECT CYLINDER
2
is
TM
2
2
Sparkling Water
TM
Quick
2
Quick
2
NON COMPATIBLE
CO SCREW SYSTEM CYLINDER
2
1
2
2
3
4
5
6
19