SOMFY SGS 201 Manuel D'utilisation page 36

operation
n operation in sequential mode
Full opening operation
l
• Press and hold the button on the remote
control.
> Both gate leaves should open.
Pressing the button again (briefly or pressing
and holding) closes the gate leaves.
Pedestrian opening operation (if
l
programmed)
• Briefly press the button on the remote
control.
> Only the gate leaf which opens first should
open.
Pressing the button again (briefly or pressing
and holding) closes the gate leaf.
n operation in automatic mode
In automatic mode, pressing the button on the remote control opens the gate. It is automatically
closed after the pre-set time delay has elapsed.
STOP
It is possible to keep the gate in the open
position by briefly pressing on the button on
the remote control during the time delay.
Pressing the button on the remote control
again closes the gate.
n operation of the 3-key control points or remote controls
The gate is opened by The gate is stopped by
pressing the Up button pressing the central button.
Three-button remote controls or control points cannot be used to open the gate for pedestrian access.
STOP
STOP
STOP
STOP
STOP The gate is closed by
pressing the Down button.
operation
n Area lighting operation
Area lighting comes on each time the motor is switched on. After the end of movement, it goes off
automatically after 2 minutes when supplied by electricity or after 30 seconds when supplied by solar
power.
n Replacing the battery
• Remove the clip on the remote control and lift the co-
ver.
• Remove the battery using a screwdriver and replace
the battery (3V CR 2430 or 3V CR 2032).
The service life of the battery is generally 2 years.
Used batteries must be returned to the distributor or
disposed of at a waste sorting centre.
n Using the remote control
If your vehicle is equipped with air conditioning and a
STOP
metallic windscreen, point the remote control towards the black band on the windscreen or through
an untreated window.
n Customising the remote controls
The coloured clips provided can be used to customise the remote controls.
n Coupling/uncoupling the cylinder
For your safety, these operations must be carried out with the power supply switched off.
Even if the power is cut off, the power supply could be restored at any moment.
In the event of a power cut, the gate
1
can be opened:
- using the back-up battery, see page
16;
- by manually uncoupling the cylinder.
Release the catch by pivoting the un-
locking mechanism. Pull the cylinder
upwards to release the catch from the
gate leaf mounting bracket.
To couple it securely, secure the
2
unlocking mechanism in the locked
position using a padlock (not supplied.
14