SOMFY SGS 201 Manuel D'utilisation page 33

4
Parameter setting
Programming the remote controls for full opening only:
l
Select the remote control button which you want to use to control your gate.
Fit the remote control on the target engraved
on the cover:
Continue to hold down the button to be
1
programmed until the PRoG indicator light
flashes slowly (the DANGER light
comes on while it is pressed).
2 Release the button: it is stored.
Programming the remote controls for pedestrian or full opening:
l
Select the remote control button which you want to use to control your gate.
Fit the remote control on the target engraved on
the cover:
Continue to hold down the button to be
1
programmed until the PRoG indicator light
flashes slowly (the DANGER light comes
on while it is pressed).
2 Release the button.
Press the button to be programmed again (within 10 seconds) until the PRoG indicator light flashes
3
slowly (the DANGER light comes on while it is pressed).
4 Release the button: it is stored.
At the end of the programming cycle, only the PRoG and on/oFF indicator lights stay on,
and the electronic system awaits programming of the gate leaves' travel.
Changing the operating mode of remote controls which have already been
l
programmed:
To change a remote control from "full opening only" mode to "pedestrian or full opening"
mode, simply carry out the "Programming the remote controls for pedestrian or full opening"
process detailed above. The most recent mode stored clears the previous mode stored.
To change a remote control from "pedestrian or full opening" mode to "full opening only"
mode, simply carry out the Programming the remote controls for full opening only" process
detailed above. The most recent mode stored clears the previous mode stored.
PROG
AUTO
ON/OFF
PROG
AUTO
ON/OFF
4
Parameter setting
Clearing the remote controls
l
• Press and hold the reset button for 7
1
seconds.
> When the button is pressed, the four
indicator lights come on.
• Release the reset button.
2
> The four indicator lights go off for
2 seconds
> The ON/OFF indicator light comes on
again.
> The PROG indicator light comes on
again.
All the programmed parameters are
programmed remote controls, gate travel, operating
mode etc.
PROG
indicator
AUTO
lights
ON/OFF
reset
button
cleared:
11