Publicité
proved ideal.
Deploy all cables neatly, wherever possible without crossing them over. It is of
•
fundamental importance never to allow a positive wire to make electrical contact with a
negative wire. Deploy all motor cables in such a way that there is no chance of them
contacting any rotating parts of the power system. Use cable ties or adhesive tape for
this.
Deploy the receiver aerial as far from all high-current wires as possible (at least 3 cm).
•
Please ensure that the only materials to make contact with the Depron surfaces are
•
foam-compatible adhesives and cleaning agents, as other solvents may dissolve and
destroy the surface.
Recommended adhesives for gluing various materials:
•
Material - material
Plastic generally - Depron
Depron - Depron
Depron - metal
Read and observe the instructions supplied with all adhesives! The building instructions inform you
when to use particular glues. If you wish to use white spirit or other solvent as a cleaning agent, note
that special safety measures are required. Read the instructions supplied with these materials.
Assembly instructions
1. Cut out the Parts List from the instructions, and the page showing the part numbers of
the laser-cut components, so that you always have direct access to this information
during the building process. This will make construction easier, and help you to
understand the instructions.
2. The first step should be to cut all the CFRP (carbon fibre) rods to the lengths stated in the
Parts List. Please keep to the sequence stated in the Parts List. Unless the
material is to be glued using UHU-por, we recommend that you sand the material
lightly at all joint positions to provide a "key" for the adhesive.
3. Glue together the four connecting wedges (21) in pairs using cyano-acrylate glue
("cyano").
4. Sand the wing joiner tubes (7) lightly, and glue the connecting wedges (21) to them, flush
with the end of the tubes.
5. Glue the wing joiner tubes (7) in the wing panels (22, 23) using 5-minute epoxy, as
shown in the following pictures.
6. The wings can now be glued to the wing centre sections (24, 25). Allow the glue to set
hard, then cut through the joiner tubes (7) in the centre using a fretsaw. Do not sand
the ends of the joiner tubes flush at this point; this is carried out when the wings
are complete.
7. Mark, say, the top left and bottom left wing panels to ensure that you join the correct
panels later. Lightly sand the wing trailing edge reinforcements (14) at one end over a
length of 40 mm.
8. Sand back the connecting wedges (21) and the wing joiner tubes (7) flush with the trailing
edge of the wing (top wings only).
63
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
ID# 0057887
All manuals and user guides at all-guides.com
Suitable adhesives
Foam cyano / UHU por
Foam cyano / UHU por
Foam cyano / UHU por
04/2007
Publicité
