Operating Instructions; Technical Data - Hilti TE 805 Mode D'emploi

1
2
3
4
Printed: 08.07.2013 | Doc-Nr: PUB / 5071241 / 000 / 01
Hilti TE 805 breaker
Items supplied as standard
– Power tool
– Side handle
– Grease
– Cleaning cloth

– Operating instructions

– Hilti toolbox
Symbols
Read the operating Return waste material
instructions before use. for recycling.
Do not use this product in any way other than
as directed by these operating instructions.
Observe the national regulations applicable
to the operation of this machine.
The operating instructions should always be
kept with the machine!

Technical data

Power input:
Voltage (versions):
Current input:
Frequency:
Weight as per EPTA-Procedure 01/2003:10.3 kg
Dimensions:
Hammering speed under load:
Single impact energy:
Chiselling performance in
medium- hard concrete:
Chisels:
Chuck:
Permanent lubrication
Adjustable side handle
Foam-rubber padded grip and side handle
Automatic cut-out carbon brushes
Electronic speed (r.p.m.) limitation
On / off switch
Protection class ll (double insulated)
Radio and TV interference suppression as per EN 55014-1
-NOTE-
The vibration emission level given in this information sheet has been measured in accordance
with a standardised test given in EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure. The declared vibration emission
level represents the main applications of the tool. However if the tool is used for different appli-
cations, with different accessories or poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total working period. An estimation of
the level of exposure to vibration should also take into account the times when the tool is
switched off or when it is running but not actually doing the job. This may significantly reduce
the exposure level over the total working period. Identify additional safety measures to protect
the operator from the effects of vibration such as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
1350 W 1350 W 1350 W 1350 W 1350 W 1350 W
100 V 110 V 120 V 220 V
13.5 A 13 A 11 A 6.5 A
50–60 Hz
600×120×230 mm
2000 blows/min.
17 joules
1200 cm 3 /min.
Ponted, flat, wide flat, asphalt and flexible chisels
Bushing, tamping and ground-rod ramming tools
TE-S
230 V 240 V
6.5 A 6.0 A
9