Wisniowski ST-2 Notice De Montage Et De Fonctionnement page 9

è
Steering unit programming mode
protection configuration ). The steering unit will set the values of both
protections automatically. If necessary, there is a possibility of changing
è
the values (Look Steering unit programming mode
è
overload protection Dynamic overload protection
P
After making these actions any other settings should be changed
depending on the needs.
ST-2 STEERING UNIT CONNECTORS DESCRIPTION:
1 - POWER SUPPLY ~ 24V
2 - POWER SUPPLY ~ 24V
3 - LAMP OUTPUT ~ 24V
4 - LAMP OUTPUT ~ 24V
5 - MOTOR OUTPUT 1
6 - MOTOR OUTPUT 2
7 - GATE CONTROL INPUT (CORRESPONDS TO THE FIRST BUTTON ON
THE REMOTE CONTROL) OPENS THE GATE WHEN "HOLD AND RUN"
FUNCTION IS ACTIVE
8 - PEDESTRIAN GATE CONTROL INPUT (CORRESPONDS TO
THE SECOND BUTTON ON THE REMOTE CONTROL) CLOSES
THE GATE WHEN "HOLD AND RUN" FUNCTION IS ACTIVE
9 - GATE OPEN DETECTOR (KRANC1)
10 - COM (GND)
11 - GATE CLOSE DETECTOR (KRANC2)
12 - STOP2 INPUT FOR STOPPING THE GATE (ACTIVE NO GND)
13 - THE BARRIER INPUT
14 - PARAMETRIC (8.2KOHM) STOP1 INPUT FOR STOPPING THE GATE
(PARAMETER 8.2KOHM CONNECTED TO 14 AND 15 INPUTS)
15 - COM (GND)
ANTENNA - CONNECTOR FOR ADDITIONAL ANTENNA MOUNTED
IN COLUMN
IX. CONFIGURATING THE STEERING UNIT
STEERING UNIT DISPLAY
ST-2 GATE STEERING UNIT
P
Technical Documentation IIiO/ST-2/12/2013/ID-91384
Assembly and Operating Instructions - ST-2 sliding gate steering unit
è
Automatic overload
è
Static
).
Fig.4
Fig.3 Extension board
EN
9