Cleaning And Disinfecting The Circuit - EMS AIR-FLOW MASTER PIEZON Mode D'emploi

Cleaning and disinfecting the circuit

"Cleaning" mode
The liquid circuit of the unit should be washed and disinfected daily.
After 13x on/off switches with no cleaning in between a blinking LED appears in order to remind
that a cleaning of the unit is needed.
The 'Cleaning' mode allows the circuit to be washed and disinfected in order to reduce the crystalline
deposits and the number of bacteria in the liquid circuit. A rinsing of the circuit is then required to avoid
a possible reaction caused by the ageing of the solution or by an unwanted mixture of liquids.
The bottle and the handpiece cords used during treatment must be present during the washing
and the disinfecting of the liquid circuit because the process is simultaneous for both elements. Remove
the handpiece.
Circuit washing cycle:
• Prepare the bottle with distilled or demineralized water,
• Press the "Purge" mode selector,
• Lift the connector and place it above a sink,
• Press the foot pedal to start the program. Three beep sounds and the blinking of the indicator
lamp of the "Cleaning" mode confi rms the end of the cycle.
Disinfecting cycle:
• Prepare the bottle with 100 ml of a compatible disinfecting solution (refer to the list of compatible
disinfectants at the beginning of this manual),
• Lift the connector and place it above a sink,
• Press the foot pedal to start the program. Three beep sounds and the blinking of the indicator
lamp of the "Cleaning" mode confi rms the end of the cycle,
• Then allow the disinfecting solution to act for 5 minutes without without interrupting the cycle or
touching the unit.
• Using the disinfecting solution, press the foot pedal to start a second cycle of the program and al-
low to act 5 minutes without interrupting the cycle or touching the unit.
40