GreenWorks Tools 2100607 Manuel D'utilisation page 21

EN
FR DE ES
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
ATTACHING GRASS DEFLECTOR See Figure 2.
Avoid contact with the blade. Failure to avoid contact
can result in serious personal injury.
„ Remove the battery pack.
„ Invert the grass trimmer/edger to access the trimmer
head.
„ Using a Phillips head screwdriver, remove
preinstalled screw from he trimmer head.
„ Place the guard on to the trimmer head.
„ Align the screw hole on he guard with the screw hole
on the trimmer head.
„ Insert the screw into the trimmer head, fastening he
guard in place.
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
Always wear eye protection. Failure to do so could
result in objects being thrown into your eyes resulting in
possible serious injury.
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
INSTALLING AN ATTACHMENT TO THE POWER HAED
See Figure 3.
„ Loosen he attachment knob on the coupler.
„ Push in the release button located on the lower tube.
Align the button with the positioning hole on the power
head coupler.
„ Slide the lower tube in to the power head coupler until
the release button engages in the positioning hole.
IT PT NL SV DA NO
English (original instructions)
WARNING
WARNING
WARNING
WARNING
WARNING
FI HU CS RU RO PL
„ Tighten the attachment knob securely.
ATTACHING THE FRONT HANDLE See Figure 4.
„ Install the main handle onto the shaft, place the bar on
the top of main handle, making sure the bar is pointing
left while holding unit.
„ Place the clam on the back side of the main handle
onto shaft.
„ Take 2 bolts provided and secure the bolts to clamp
with Philips screw driver (not provided).
OPERATION
Hold the power head with your right hand on the rear handle
and your left hand on the front handle. Keep a firm grip with
he
both hands while in operation. Power head should be held
at a comfortable position with the rear handle about hip
height. Always operate power head at full throttle. If debris
becomes wrapped around the attachment, RELEASE THE
SWITCH TRIGGER, and remove the debris.
Use the harness when operation.
TO INSTALL BATTERY PACK See Figure 5.
„ Place the battery pack in the trimmer. Align raised ribs
on battery pack with grooves in the trimmer's battery
port.
„ Make sure the latch on bottom of the battery pack
snaps in place and that battery pack is fully seated and
secure in the trimmer before beginning operation.
TO REMOVE BATTERY PACK See Figure 5.
„ Release the switch trigger and lock-out trigger to stop
the trimmer.
„ Press the power button to turn off the trimmer.
„ Press and hold the battery latch button at the bottom of
the battery pack.
„ Remove battery pack from the trimmer.
STARTING/STOPPING THE TRIMMER See Figure 6.
„ Press the on/off power button.
„ To start the trimmer, grip the front handle with one
hand while holding the rear handle wi h your other
hand making sure to depress the lock-out trigger while
squeezing the variable speed trigger.
„ To stop the trimmer, just release the variable speed
control trigger.
18
SL HR ET LT LV SK BG