Electrical Hook-Up Of The Hood - Sirius S-DD2 FSEE Instructions Pour L'emploi

- ELECTRIAL HOOK UP OF THE HOOD
WARNING: Place the metal box containing the electronic components at a distance of no
less than 65 cm from gas-operated cook tops or in any case, 65 cm from the extraction
point of the hood.
RECOMMENDATION: We recommend installing the metal box containing the electronic
components at least 10 cm above floor level and at a suitable distance from all heat
sources (e.g. oven sides or cook top).
This appliance is fitted with an H05 VVF 3 conductor, 0.75 mm2 (neutral, phase, and
ground) power cable. This can be hooked up to a 220 – 240 V mono-phase electrical net-
work by way of a CEI 60083 regulation power socket that must remain accessible after
installation, in conformity to installation regulations.
We decline all responsibility in case of accident caused by a lack of ground connection or
incorrect ground connection. The appliance must be fed through a differential protection
device (RCD), with a nominal residual current not exceeding 30mA. If the power cable is
damaged, call the after-sales service to avoid any risk.
The connection of Downdraft to the electric network must be carried out by qualified and
skilled technicians.
The cooker hood can only be connected to one electric network, properly arranged and
installed.
The electric system must comply with the VDE0100 standard.
Attention
If the hood presents some form of anomaly, unplug the appliance or remove the fuse corre-
sponding to the appliance's power line.
If the appliance has no plug or if the plug is not easily accessible, then a device needs to be fit-
ted to cut it off from the mains electricity; this device must have an opening distance between
contacts on all poles of at least 3 mm.
ELECTRIAL HOOK UP
This appliance conforms to the European Directives 2006/95/EC (Low Voltage Directive)
and 2004/108/EC (Electromagnetic Compatibility).
When you install the appliance and carry out maintenance, it must be unplugged from the
power source or the fuses must be disengaged or removed. Electrical hook up must be carried
out before the appliance is installed in the cabinet.
Check that:
- the power source is sufficient,
- power cords are in good condition,
- The diameter of the cables conforms to installation regulations.
20