Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4/ CLEANING THE HOOD
Careful maintenance helps guarantee proper operation and good results from an appliance
over time.
The hood must be unplugged from the electrical power source, both by unplugging
the appliance from the socket as well as de-activating the breaker, before removing the
metal filters. After cleaning, you must replace the metal filters as outlined in the instruc-
tions.
MAINTENANCE
External surfaces and
accessories
Charcoal filter with extract-
able unit open
Active carbon filter
HOW TO PROCEED?
Do not use metallic scrub-
bers, abrasive products, or
hard brushes.
After 30 hours of function-
ing, the downdraft will sig-
nal the grease filter satura-
tion.
In the TC model, the grease
filter saturation is signalled
through a flashing of the
4 central leds, while in the
push-button model all keys
will flash.
For both models, the re-
set function is activated by
pushing the timer key
while the extractable unit is
open.
In the recirculation mode,
you must substitute the ac-
tive carbon filter periodically.
To remove the carbon filter
it is necessary first of all to
remove the grease filter and
then to pull the plastic key of
the panel itself to remove it
from its seating.
Follow these steps in reverse
order to insert the active car-
bon filter.
Replace the used carbon fil-
ter on an average of every six
months.
23
ACCESSORY PRODUCTS TO
USE
To clean the external sur-
faces of the hood and the
light housing screen use
only commercially available
household detergents dilut-
ed in water. Then rinse with
clean water and dry with a
soft cloth.
The grease filters can be
washed by hand or in the
dishwasher.
These
need to be cleaned on a reg-
ular basis because otherwise
they may present a fire risk.
Refit the grease filters and
front panel, making sure that
the panel is properly fitted at
the sides so that it does not
cause the downdraft to stop
operating.
EN
filters
Publicité
Table des Matières
