Utilisation; Mounting The Carbon Filter - Sirius S-DD2 FSEE Instructions Pour L'emploi

Pushing the ON/1 button (Fig. 22B for SDD2 and 15H for SDD2 TC) the aspiration panel rises.
After it has reached a height of 180 mm from the cooketop, press OFF, to stop the extraction
then the Timer and after 2 sec. the OFF button. The downdraft will carry out the calibration of
its aspiration panel rising and retracting for some centimeters. During this phase, the buttons
on the pushbutton control panel blink. At the end of the calibration, the aspiration panel get
back to the previous position and the button end to blink. Wait until the aspiration panel stops
moving before re-activating the extraction.

UTILISATION

This product is intended to extract fumes, fats, and steam from cooking. It is designed to work
in both suctioning mode, with outside evacuation, and filtering mode.
VERSION EVACUATION exterior
The hood is equipped with an air outlet to convey smoke outwards (the flue pipe and fixing
flange are not supplied).
Check valve blockage
Warning: Before connecting the air exhaust hose, make sure that the check valves are free to
turn over freely.
For hoods with outside air exhaust, fit a check valve to prevent wind and returning air from
entering.
Filtering mode
In case fumes and vapour cannot be evacuated outside, the appliance can be used in the filter-
ing mode. Carbon filters are required for this type of hood. Air recycled through the charcoal
filters is reintroduced into the kitchen, thanks to a duct conveying the air on one side of the
cabinet (Fig. 14 bis).
Installation must conform to the regulations in force regarding the ventilation of
enclosed environments. In particular, discharged air must not be channelled into a con-
duit used for exhaust discharge or discharge from devices that operate with gas or other
combustible materials. The use of unused conduits is not permissible without the ap-
proval of a qualified technician.
- GREASE FILTER REMOVAL

- MOUNTING THE CARBON FILTER

The removal and fitting of the grease and carbon filters need to be carried out with the down-
The removal and fitting of the grease and carbon filters need to be carried out with the down-
draft in the open position. To open the downdraft, push the ON/1 key. Then remove the front
draft in the open position. To open the downdraft, push the ON/1 key. Then remove the front
panel, (Fig.8). The panel will rotate forwards to make it possible to access the grease filters
panel, pushing the upper part of each side at the same time. The panel will rotate forwards
(Fig.16). Remove the grease filters to access the carbon filters (Fig.17). The replacement of the to make it possible to access the grease filters (Fig. 16). Remove the grease filters to access
the carbon filters (Fig. 17). The replacement of the charcoal filters has to be carried out ac-
charcoal filters has to be carried out accordinglyto the effective use of the Downdraft, and in
cordingly to the effective use of the Downdraft, and in any case at least once every 6 months.
any case at least once every 6 months.
After having replaced the filters, reinstall the front stainless steel panel, otherwise
the Downdraft is not enabled to function.
19