Electrical Hook-Up Of The Hood; Useful Advice - Sirius DOWNDRAFT S-DD2 EMTC 1180 Instructions Pour L'emploi

- ELECTRIAL HOOK UP OF THE HOOD
WARNING: The electronic board for the controls needs to be installed beneath the work
top, close to the body of the hood and at a minimum distance of 65 cm from all substances
or ducting for flammable substances (gas pipes or ducting for specific liquids)
USEFUL ADVICE: We recommend fitting the electronic board at a height of at least 10 cm
from the ground and at a suitable distance from all heat sources (e.g., the side of an oven
or cook top).
This appliance is fitted with an H05 VVF 3 conductor, 0.75 mm2 (neutral, phase, and
ground) power cable. This can be hooked up to a 220 – 240 V mono-phase electrical net-
work by way of a CEI 60083 regulation power socket that must remain accessible after
installation, in conformity to installation regulations.
We decline all responsibility in case of accident caused by a lack of ground connection
or incorrect ground connection. The fuse used must be 10 or 16 A. If the power cable is
damaged, call the after-sales service to avoid any risk.
Attention
If the hood presents some form of anomaly, unplug the appliance or remove the fuse corre-
sponding to the appliance's power line.
If the appliance has no plug or if the plug is not easily accessible, then a device needs to be fit-
ted to cut it off from the mains electricity; this device must have an opening distance between
contacts on all poles of at least  mm.
ELECTRIAL HOOK UP
This appliance conforms to the European Directives 2006/95/EC (Low Voltage Directive)
and 2004/108/EC (Electromagnetic Compatibility).
When you install the appliance and carry out maintenance, it must be unplugged from the
power source or the fuses must be disengaged or removed. Electrical hook up must be carried
out before the appliance is installed in the cabinet.
Check that:
- the power source is sufficient,
- power cords are in good condition,
- The diameter of the cables conforms to installation regulations.
Attention
After having finished the installation of the downdraft, plug-in the unit, lift it and remove
the blocking panel (Fig. -6-7). Afterwards please open the panel (Fig. 8-9) and remove the
grease filter PVC protection (Fig. 10) and place the filter back (Fig. 11)
0