Wheels; Front Wheel Removal And Installation; Rear Wheel Removal - Schindelhauer Bikes Arthur 2020 Notice D'utilisation

7.7 Wheels

Don't pull the brake lever with the wheel removed. The
!
gap between the brake pads would otherwise become
too small to insert the brake disc.
EN

7.7.1. Front wheel removal and installation

1. Loosen the through axle (6 mm hex key) and pull it out of the fork drop
outs to the left side of the e-bike.
2. Now you can remove the front wheel from the fork in a downward
motion.
3. Installation of the front wheel is carried out in reverse fashion. Take care
that the brake disc is gently inserted between the brake pads.
4. Tighten the through axle to a torque of 10 Nm.
Make sure to carry out each of these steps with the utmost
care and diligence. If in doubt, please do not hesitate to
contact your specialist dealer.

7.7.2. Rear wheel removal

1. Loosen the silver plate (Torx 25) so that you can press the motorcable
downwards (fig. 17 ) . Then unplug it from the cable (fig. 18 ) .
2. Loosen the axle bolts (8 mm hex key) on both sides and remove the
rear wheel in a downward motion (fig. 19 ) . The belt tension will auto-
matically relieve due to the angled opening of the dropout sledges
(fig. 20 ) .
3. You can now take the belt off the rear sprocket (fig. 21 ) .
76
17
18
19