Support Modes; Lighting; Bluetooth®-Connection And Notifications - Schindelhauer Bikes Arthur 2020 Notice D'utilisation

3.5.2. Support modes

Briefly press the button on the iWoc Remote. The LED starts flashing in
the colour of the current assistance mode. Pressing the button again will
switch cyclical through the different modes from WHITE (no assistance) to
RED (strongest assistance mode). After choosing your desired assistance
EN
mode the LED will go back to indicating the current battery charging level.
Support modes:
i
OFF

3.5.3. Lighting

Shortly press the button on the iWoc Remote. The LED will start flashing.
Then press the button longer until the LED turns YELLOW indicating that
the light has turned on.
To turn the light off simply repeat this process.
If the display indicates an empty battery, the lighting
i
system can be used for another hour. Make sure that the
battery level is sufficient to guarantee lighting for the
duration of your planned ride, especially when riding in
the dark.
60
mode 1 mode 2 mode 3
3.5.4. Bluetooth®-connection and notifications
When you turn on your e-bike system, it automatically connects to the
last smartphone it was connected to and which is currently in range
(Bluetooth® must be enabled). A successful pairing and an interruption
of the connection will be indicated by the LED lighting up BLUE for a short
while.
When you receive a notification or call on the connected device, the LED
will indicate that by lighting up in LIGHT BLUE for a short while.
The e-bike system is connected to your
i
smartphone via Bluetooth® connection.