EUROM Sani Towel 500 Mode D'emploi page 26

Open window mode
•
Press the Mode button and the Plus button simultaneous to activate the open window
function, F0 appears on the display.
•
Press the Mode button and the Minus button simultaneous to deactivate the open
window function, FF appears on the display.
•
When the ambient temperature decreases 2°C or more within 2 minutes, the device will
go in standby mode and F0 starts flashing on the display.
Button lock
To prevent damp towels from accidentally activating the buttons, the buttons can be locked.
•
Press the Plus and Minus buttons simultaneous until a beep sounds to activate and
deactivate the button lock:
•
When the button lock is active the display will show LC alternating with mode specific
messages.
After operation
CAUTION
Do not use the power cable to unplug the device. Do not wind the power cable
too tightly or in sharp corners. Do not wrap the power cable around the
device.
1. Press the ON/OFF button (Figure 10, pos. 2) to put the device in standby mode.
2. Disconnect the power plug from the power outlet (Figure 10, pos. 1).
3. Let the device cool down before touching it.
4. Wind the power cable.
Maintenance
WARNING
Do not perform any repairs or modifications to this device.
Maintenance and repairs must be carried out by a EUROM authorized professional. If the
electric cable and/or electric plug are damaged, it should be replaced by the manufacturer or
its service employee or persons with similar qualifications to prevent risks.
Cleaning
WARNING
The device becomes very hot. Make sure the device is turned off, unplugged
and completely cooled down.
26