vii | Warnings and Safety Instructions
WARNINGS AND SAFETY INSTRUCTIONS
WARNING — Risk of fire or explosion from flammable vapors. Do not store gasoline, cleaning fluids, varnishes,
paints, or other volatile flammable liquids near heater.
WARNING — Risk of explosion if unit is installed near G31 gas storage. G31 gas is heavier than air. Consult
local codes and fire protection authorities about specific installation requirements and restrictions.
Locate the heater away from propane gas storage and filling equipment as specified by the Standard
for the Storage and Handling of G31 (latest edition).
WARNING — Risk of fire. Do not place articles on, near or against the heater.
WARNING — Risk of burn hazard. To reduce the risk of injury, do not touch the side heater vent cover when
the heater is operating. Side heater vent covers are HOT and can burn when touched causing
personal injury. Do not allow children to play on or around heater or associated equipment.
Vent
THE AVERAGE TEMPERATURE OF THE HEATERS FLUE EXHAUST IS 204 DEGREES
Cover
CELSIUS (°C).
WARNING — Risk of asphyxiation if exhaust is not correctly vented. Follow venting instructions exactly
when installing heater. Do not use a draft hood with this heater, as the exhaust is under
pressure from the burner blower and a draft hood will allow exhaust fumes to blow into the room
housing the heater. The heater is supplied with an integral venting system for outdoor installation.
CAUTION — Label all wires prior to disconnection when servicing controls. Wiring errors can cause
improper and dangerous operation. Wiring errors can also destroy the control board.
• Connect heater to 240 Volt, 50 Hz., Single Phase power only.
• Verify proper operation after servicing.
• Do not allow children to play on or around heater or associated equipment.
• Never allow children to use the pool or spa without adult supervision.
• Read and follow other safety information contained in this manual prior to operating this pool heater.
GENERAL SPECIFICATIONS
NOTICE:
•
Combustion air contaminated by corrosive chemical fumes can damage the heater and will void the warranty.
•
The Combination Gas Control Valve on this heater differs from most appliance gas controls. If it must be replaced,
for safety reasons replace it only with an identical gas control.
•
The access door panels must be in place to provide proper ventilation. Do not operate the heater for more than five (5)
minutes with the access door panels removed.
•
This heater is design certified by CERTIGAZ as complying with the Standard for Gas Fired Pool Heaters, and is intended
for use in heating fresh water swimming pools or spas.
•
The heater is designed for the heating of chlorine, bromine or salt system swimming pools and spas. It should NOT be
used as a space heating boiler, or general purpose water heater. The heater requires an external 240 VAC
single-phase electric power source.
•
The heater should be located in an area where leakage of the heater or connections will not result in damage to the
area adjacent to the heater or to the structure. When such locations cannot be avoided, it is recommended that a
suitable drain pan, adequately drained, be installed under the heater. The pan must not restrict air flow.
•
The heater may not be installed within 3.5 m (11.5 ft.) of the inside surface of a pool or spa unless it is separated by a
solid fence, wall or other permanent barrier.
™
MASTERTEMP
Pool and Spa Heater Installation and User's Guide
All manuals and user guides at all-guides.com
(continued)
P/N 475106 Rev. D 1/2016