Publicité
Les langues disponibles
Les langues disponibles
8 | Section
1. Installation
PUTTING THE HEATER INTO SERVICE
If the heater is installed below the level of the pool, or more than 0.6 meters (2 feet) above pool level, the pressure switch
setting should be adjusted. See "WATER PRESSURE SWITCH" in the "SAFETY CONTROLS Section" (page 5) and
the "CAUTION" under "BELOW POOL INSTALLATION Section" (see page 10).
Before putting the heater into service for the first time, follow the instructions under "BEFORE START-UP" (page 3) in
the front of this manual. Check for proper operation of the heater by following the steps under, see page 4 "OPERATION
INSTRUCTIONS."
Notice: Damage to equipment caused by improper installation or repair will void the warranty.
SPECIFICATIONS
These installation instructions are designed for use by qualified personnel only, trained especially for installation of this
type of heating equipment and related components. Some states require installation and repair by licensed personnel. If
this applies in your state, be sure your contractor bears the appropriate license. See Figure 9 for Outdoor Installations.
DIMENSIONS IN CENTIMETERS & INCHES
406 mm
(16")
EXHAUST SIDE
Figure 9.
™
MASTERTEMP
Pool and Spa Heater Installation and User's Guide
All manuals and user guides at all-guides.com
715 mm
(28")
FRONT
ELECTRICAL
CONDUIT PORT
715 mm
(28")
578 mm
(23")
406 mm
(16")
585 mm
(23")
828 mm
(31")
TOP
PLUMBING SIDE
533 mm
(21")
63 mm
(2" - UK)
257 mm
(10")
142 cm
(6")
P/N 475106 Rev. D 1/2016
Publicité
