Télécharger Imprimer la page

Grundfos DMS 2 Notice D'installation Et D'entretien page 10

Variant b

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
4.2 Start/stop of pump
The pump can be started/stopped in two different
ways:
• Locally on the pump control panel.
• By switching on/off the electricity supply.
4.3 Priming/venting of pump
The pump control panel incorporates a
Press this button if the maximum pump capacity is
required over a short period, e.g. during start-up.
When the button is released, the pump automatically
returns to the previous operating mode.
During priming/venting, it is recommended to let the
pump run without a counter pressure or to loosen the
vent valve by giving it a 1/8 to 1/4 turn.
Note: When the buttons
simultaneously, the pump can be set to run for a spe-
cific number of seconds at maximum capacity. The
remaining number of seconds will appear in the dis-
play. The maximum value is 300 seconds.
4.4 Indicator lights
The green and red indicator lights on the pump are
used for operating and fault indication.
The functions of the indicator lights appear from the
table below:
Green
Condition
LED
Pump running
On
Set to stop
Flashing
Pump fault
Off
Supply failure
Off
Overheating
Off
10
button.
100%
and
are pressed
100%
Red
Display
LED
Normal
Off
indication
Normal
Off
indication
On
EEPROM
Off
Off
MAX.
On
TEMP.

Publicité

loading

Ce manuel est également adapté pour:

Dms 4Dms 8Dms 12