Using The Microphone Keypad; Clearing A Memory Channel - Kenwood TM-281A Mode D'emploi

U M K
SING THE ICROPHONE EYPAD
You can also recall a Memory Channel by entering a
desired Memory Channel number with the microphone
keypad.
1 Press [MR] to enter Memory Recall mode.
2 Press the microphone key assigned the ENTER
function.
3 Enter the channel number using the microphone
keypad.
• For single-digit channel numbers, enter "0" first or press
Mic Enter after entering the channel number.
• For two-digit channel numbers that begin with "1", press
Mic Enter after entering the channel number.
Note:
You cannot recall an empty Memory Channel. An error beep
◆
sounds.
You cannot recall the Program Scan Memory Channels
◆
(L0/U0 ~ L2/U2), the Priority Channel (Pr), and the Weather Alert
Channel (AL) (K market models only) using the numeric keypad.
When you recall an odd-split memory channel, "+" and "–"
◆
appear on the display. Press [REV] to display the transmission
frequency.
After recalling a Memory Channel, you may modify data such
◆
as Narrow Band, Tone, or CTCSS. However, these settings are
cleared once you select another channel or the VFO Mode. To
permanently store the data, overwrite the channel contents.

CLEARING A MEMORY CHANNEL

To erase an individual Memory Channel:
1 Recall the Memory Channel you want to erase.
2 Press [ ] (Power) (1s) to switch the transceiver OFF.
3 Press [MR]+[ ] (Power).
• An erase confirmation message appears.
4 Press [MR] to erase the channel data.
• The contents of the Memory Channel are erased.
• To quit clearing the Memory Channel, press any key other
than [MR].
Note:
You can also clear the Priority Channel and L0/U0 ~ L2/U2 data.
◆
(The Call Channel cannot be cleared.)
To clear all Memory Channel contents at once, perform a Full
◆
Reset {page 67}.
You cannot clear channels while in Channel Display Mode.
◆
7
31