Display - Kenwood TM-281A Mode D'emploi

In MR Mode, press [F] then press [VFO] to transfer
the contents of the selected Memory Channel to the
VFO {page 33}.
t MR key
Press to enter Memory Recall Mode {page 30}. In this
mode, you can change memory channels using the
3
Tuning control or Mic [UP]/[DWN]. Press and hold
for 1 second while in Memory Recall Mode to begin
Memory Scan {page 42}.
Press [F], use the Tuning control to select the desired
channel, then press [MR] to reprogram the Call
Channel or a Memory Channel {page 29}.
y REV key
Press to switch the transmit frequency and receive
frequency when operating with an offset {page 23} or
an odd-split Memory Channel {page 28}.
Press [F] then press [REV] and rotate the Tuning
control to increase or decrease the squelch level
{page 14}.
u
/F key
Press and hold for 1 second to lock the transceiver
keys {page 58}.
Press momentarily to access the second functions of
the transceiver keys.
10

DISPLAY

1 2 3 4
17 16 15
1
Appears when the CTCSS function is activated {page 46}.
2
Appears when the Tone function is activated {page 24}.
3
Appears when the DCS function is activated {page 48}.
4
Appears when the repeater shift function is activated
{pages 23, 30}. (" " is not used on this transceiver.)
5
Appears when the Reverse function is activated {page 26}.
5 6 7 9 10 11
14 13 12