Step 3 - Setting Up The Nursery Unit; Power On/Off; Step 4 - Turning On Your Monitor - Angelcare AC1300 Manuel De L'utilisateur

STEP 3 - SETTING UP THE NURSERY UNIT

1
3
4
NURSERY UNIT:
A
B
C
D
Front Side
* Nursery Unit may be installed on a tripod (not included).

STEP 4 - TURNING ON YOUR MONITOR

1 2
When Parent Unit is
turned ON and Nursery
Unit is OFF, Parent Unit
will display Disconnected
mode and will turn itself
OFF after 60 seconds.
All manuals and user guides at all-guides.com
2
3 ft
(0.9 m)
L
Back Side
1) Press and hold the Parent Unit ON/OFF
2) Push and hold the Nursery Unit Power
3) The Parent Unit will display Video mode
1) Remove the battery door and insert
3 AA Alkaline Batteries (not included).
2) Place the Nursery Unit at a minimum
of 3 feet (0.9 meter) away from the crib.
3) Connect the adapter to the Nursery
Unit and into an electrical outlet.
4) Direct the angle of the camera toward
the crib using the rotating dial.
NOTE:
The batteries maintain power
supply in case of power outage.
A) Adjustable Camera
E
B) Power ON Indicator
C) Photo Sensor
D) Microphone
F
E) Rotating Dial
for Camera Angle
G
F) Pager/Hold Button
G) POWER ON/OFF
H) Adapter Outlet
I) Sensor Pad Outlet
H
J) Battery door (Not shown)
I
K) Tripod Outlet*(Not shown)
L) Night Light ON/OFF
J
K
button for 2 seconds until LCD screen
is turned ON. Angelcare's logo will be
shown for 1 second.
ON/ OFF button for 2 seconds.
screen.
1) If there is a lost connection between
the 2 units after 1.5 minutes, the
Out-of-Range alarm will sound
on the Parent Unit (refer to
troubleshooting):
• The Out-of-Range icon will appear
on the screen.
• The Lost Connection icon will appear
on the indicator bar.
E
N
9