Step 3 - Setting Up The Nursery Unit - Angelcare AC601-A Manuel Du Propriétaire

6
8 cm
7
CLIC!
4 3 2
8 9
4
3
2
1
10
WARNING
STRANGULATION HAZARD
• Remove all slack from Sensor Pad Cord.
• When lowering the mattress support
as your child grows, slide the vertical
Cord Cover (5) upward so it remains
approximately in the center between
the mattress support and the floor. Slide
the Sensor Pad Cord through the Floor
Cover to eliminate any additional slack.
12
6
6) Place the 6
th cord cover approximately
3 in. (8 cm) from the edge of the
mattress support.
7) Snap together the remaining cord
covers that will run along the floor.
8) Remove any cord slack to make sure
no parts of the cord are loose.
9) Peel off the double-sided tape on the
4 th cord cover and place it securely
1
under the crib leg.
10) Install the Nursery Unit on a flat, stable
surface facing the crib at a distance of
at least 0.9 m (3 ft) and plug the Sensor
Pad cord into the Nursery Unit.
11) Check to make sure the Sensor Pad has
not moved from position.
12) Place the mattress back inside the crib.
The Sensor Pad functions with any size
and type of mattress except memory-foam
mattresses and hollow frame mattresses.
The hardboard maintains a constant
pressure on the Sensor Pad, enabling it to
detect the baby's movements even when
the baby is at the edges of the crib.
• The Sensor Pad is not designed for use
with adults, children or infants older
than 24 months.
• Discontinue used of the Sensor Pad
when child is older than 24 months.
Remove Sensor Pad from crib and store
for future use.
• BEFORE FIRST TIME USE: To test
that the unit is ready for use, refer to
instruction manual on how to test that
the installation has been done.

STEP 3 - SETTING UP THE NURSERY UNIT

1
2 3
Keep
at least
3 feet (0.9 m)
6
apart
5
4 3 2 1
NURSERY UNIT:
D
E
A H
F
B
G
I
C
Front Side
1) Remove the battery cover and insert
4 AAA Alkaline Batteries ( not included).
2) Place the Nursery Unit at a minimum
of 3 feet (0.9 m) away from the crib.
3) Connect the AC Adapter to the Nursery
Unit and plug into an electrical outlet.
NOTE:
The batteries maintain power
supply in case of power outage.
A) Left 'Wing' - Channel
Selection (A, B, C)
B) Power Indicator / Low
Battery Indicator
C) POWER ON/OFF
J
D) Night Light Button /
Out-of-Range Function
E) Out-of-Range Indicator
F) Movement Indicator
K
G) Microphone
H) Right 'Wing' -
L
Detection Mode
• Sound and Movement
M
• TIC OFF
• Sound Only
I) Sensor Pad Outlet
J) Night Light
K) Alarm Sound Speaker
N
L) Sensor Pad Sensitivity Dial
M) AC Adapter Outlet
Back Side
N) Battery Door
(not shown)
E
N
13