EUROM WALL DESIGNHEAT 2000R Manuel D'utilisation page 24

5. Press ; you will see P1 (programme 1) on the display. A maximum of six
programmes can be set per day: P1 to P6. Press "EDIT" again to go to P2, and so on.If
you set the programme to programme 1 (P1), the display will show Fig. F (flashing).
6. Press ; the display will show "00". Press "TIME/ON" to increase the start time by
one hour, from 0 to 23, e.g. 07.00 (see Fig. G).
; the display will show the start time. Press "TIME/OFF" to increase the start
7. Press
time by one hour, e.g. to 13.00 (Fig. H). The stop time must always be later than the
start time. If both times are the same, the unit will switch to standby.
8. Press the plus and minus buttons to set the required temperature.
9. While the display is flashing, you can change a setting or go to the next setting. If you
wait too long, the setting will be cancelled.
10. Finally, press OK to confirm the setting.
11. Repeat steps 3 to 8 to set a weekly programme of start and stop times, for 7 days and
up to 6 programmes per day.
12. Follow the steps described above to change a setting. This will overwrite the previous
values. Confirm using the "OK" button.
13. To turn the weekly programme off, press "P" again. The "P" disappears from the
display and you leave the weekly programme. The unit returns to its previous settings.
N.B.! The weekly programme is continuous, which means that it returns to day 1 at the
end of day 7. If that is not what you want, you should turn the weekly programme off using
the "P" button.
Comments:

To check the settings, press "DAY", "EDIT", "TIME/ON" then "TIME/OFF". The display
will show the settings.

The timer can only be set to hours, not minutes.
 The "TIME/OFF" time must always be later than the "TIME/ON" time.

Your settings will be lost if the unit is switched off using the main switch, if there has
been a power cut or if the plug has been removed from the socket. Press "SET" to
check the day and time and set them again if necessary.
Set open window detector:

Make sure the unit is switched on and heating up.

Press ; the display shows the corresponding icon and the temperature (°C). The
standard temperature is 23 °C; you can change this using the plus and minus buttons.
When open window detection is switched on, the unit will switch off if the temperature
in the room drops by between 5 and 10 degrees within 10 minutes, and go to standby.
In this case, you can turn the unit on again using the on/off button.
24