EUROM WALL DESIGNHEAT 2000R Manuel D'utilisation page 19

Technical data
Type
Supply voltage
Maximum capacity
Settings
Heating elements
Timer
Thermostat
Remote control
Dimensions
Weight
General safety instructions
1. Before using the machine, carefully read this entire instruction manual.
2. Before using your new heater, check it, including cord and plug, for any visible
damage. Do not use a damaged heater, but send it back to your dealer for
replacement.
3. This heater has been designed to hang securely from the wall: the outlet opening has
to point downwards. Do not use it until it has been properly installed, as described in
these instructions for use and never, for example, in a standing position or when
leaning against something.
4. This heater is strictly intended for normal domestic use. Only use it as an additional
heater in your home.
5. This heater in not suitable for use in wet or damp spaces such as bathrooms and
laundry rooms. Do not place the heater in the vicinity of taps, bathtub, shower, pool,
fountains or other sources of moisture. Make sure it cannot fall into water and prevent
water from getting into the heater itself. If, at any time, the heater does fall into water,
unplug it immediately! Do not use a heater that has a damp interior but have it repaired.
Never immerse the heater, cord or plug in water and never touch it with wet hands.
6. Do not install this appliance behind a door or next to an open window, where rain could
make it wet.
7. The supply voltage and utility frequency, specified on the machine, need to match
those of the socket that is used. The electrical installation needs to be protected by a
residual current device (max. 30 mAmp).
8. Fully extend the cord before plugging in the heater. Make sure it does not come into
contact with any part of the heater and prevent it from heating up any other way. Do not
run the cord underneath carpeting; do not cover it with mats, carpet strips, or similar
and make sure it is not placed in any passageways. Make sure the cord cannot be
stepped on and that no furniture is placed on top of it. Do not lead the cord around
sharp corners and do not roll it up too tightly after use!
9. If possible, do not use an extension cord, as this poses the risk of overheating and fire.
If the use of an extension cord is unavoidable, then make sure it is an undamaged,
approved extension cord with a minimum diameter of 2 x 2.5 mm² and a minimum
permissible power of 2200 Watt/10Amp. To prevent overheating, always fully extend
the cord!
English
WALL DESIGNHEAT 2000R
Volt/Hz 220-240 / 50
Watt 2000
0–1000 – 2000
Watt
PTC
for up to 7.5 hours plus weekly programme
+
+
cm 46 x 12 x 19
kg 2
19