EUROM WALL DESIGNHEAT 2000R Manuel D'utilisation page 21

24. Do not turn on the appliance if you have discovered damage to the appliance, cord or
plug, if the appliance is malfunctioning, if it has been dropped or if there are signs of
any other defect. Return the complete product to the vendor or to a certified electrician
for inspection and/or repair. Always ask for original parts.
25. Do not use attachments and/or accessories, not recommended or supplied by the
manufacturer.
26. The appliance (incl. cord and plug) may only be opened and/or repaired by properly
authorised and qualified persons.
27. Only use this heater for its intended purpose and as described in this instruction
manual.
Not abiding by instructions 24, 25, 26 & 27 may lead to damage, fire and/or personal
injuries. A failure to adhere to these rules also immediately nullifies the guarantee and
vendor, importer and/or manufacturer do not take responsibility for any of the
consequences!
WARNING! Some parts of this product could become very hot and cause burns. Be
especially careful if children or vulnerable persons are in the immediate vicinity.
Description
Location and Connection

Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.

Select a suitable place for the device, taking into account the safety instructions. The
WALL DESIGNHEAT 2000R has to be hung from a wall and therefore may not be
used in a lying, leaning, hanging or standing position! The wall on which the device is
hung has to be firm, flat and perfectly vertical and made from non-inflammable
material that cannot melt. It has to be at least 20 cm away from side walls and the top
has to be at least 180 cm above the floor.
The heater has to preferably be positioned at and permanently connected to an
electric socket. This connection may only be made by a qualified electrician and, for
that reason, is not described here.
In this booklet, for reasons of safety, use with a plug should be assumed; when
there is a permanent connection, any passages about the plug do not apply.

Drill two holes in the wall at the required locations, to fit the plugs exactly: make sure
these holes are horizontal and 39.4 cm apart. Insert plugs and screws into the holes.
Allow the screws to stick out by 10 mm. Hook the heater over the screws using the
hanging eyes, then slide to the left and pull downwards. The fixing material supplied is
suitable for brick walls. Consult a specialist, for instance at a DIY store, if your wall is
built of other material.
21
A = Main switch
B = Flap
C = Display
D = Timer button
E = F-button (function)