Serial Number And Ce Marking; Introduction; Unpacking The Machine; Consumables - Tennant S8 Mode D'emploi

1.2 -SERIAL NUMBER AND CE MARKING

Always ensure that the machine is provided with a rating plate
giving the serial number and CE marking in the position shown
in Fig.1.
If this is not the case, notify your dealer immediately.
Fig.1

1.3 -INTRODUCTION

The purpose of this manual is to inform the operator of the ba-
sic rules, safety rules and criteria which must be observed when
using, adjusting and maintaining the machine. The machine has
been designed and manufactured to ensure an excellent perfor-
mance and the utmost comfort and ease of operation in a variety
of working conditions. Before delivery, the machine has been che-
cked at our factory and by our dealer to make sure it is handed
over to you in perfect working order. To maintain the machine in
this condition and ensure problem free operation, it is essential to
follow the routine maintenance instructions given in this handbook.

1.4 -UNPACKING THE MACHINE

Unpack the machine with the utmost care; avoid carrying out any
operation that could damage it. Once it has been unpacked, check
whether it is damaged. If you notice that it is not in correct working
order, DO NOT use it and inform your dealer.
For packaging and transport purposes, some parts and accesso-
ries are supplied disconnected from the machine. To assemble
them, carefully follow the instructions given in the relevant sec-
tions.
Contents of package:
1 Machine.
1 Side brush.
1 Instruction manual
2 Bumper Wheels and mounting hardware
Tool Kit Package: (p/n 9001420):
1x 4mm Allen Wrench – To remove the rear shroud in order to
access bolts for handle adjustment
1x 5mm Allen Allen Wrench – To adjust the height of the side brush
2x 10/13mm Wrench - To attach handle from shipping position.
To install the side brush and to attach cables to battery posts.
2x M8screw and nut
2x Ignition key
1x Charger LED label
In the case in which one of the above mentioned parts is missing,
please inform your dealer right away.
Take care to keep the packaging materials (bags, cartons, pallets,
hooks, etc) out of the reach of children.
For security reason during the transport, the star-
NOTE
ting keys are included in the envelop with the do-
cuments.

1.5 -CONSUMABLES

Reduction gear: MOVIBLAK 300 lithium grease with similar cha-
racteristics.
Battery: Distilled water.

2.1 -PREPARING THE MACHINE FOR OPERATION

2.1.1 -Mounting the side brush
- Switch the brush lift lever (1 Fig.3), to OFF.
- Screw out the screw from the side brush shaft.
- Fit the brush on the shaft (Fig.2).
- Screw on the screw and washer.
Fig.2
2.1.2 - Mounting the handlebar
- Remove the shroud to access the handlebar mounting
screws. 4mm Allen wrench required, supplied with machine
(Fig.2/A).
Fig.2/A
- Withdraw the handlebar fixing screws.
- Lift the handlebar into the work position (1 Fig.2/B).
- Tighten the handlebar fixing screws.
1
Fig.2/B
- 6 -