Serial Number And Ce Marking; Introduction; Unpacking The Machine; Consumables - Tennant S8 Mode D'emploi Et Pièces Détachées

1.2 -SERIAL NUMBER AND CE MARKING

Always ensure that the machine is provided with a rating plate giving the
serial number and CE marking in the position shown in Fig.1.
If this is not the case, notify your dealer immediately.

1.3 -INTRODUCTION

The purpose of this manual is to inform the operator of the basic rules,
safety rules and criteria which must be observed when using, adjusting
and maintaining the machine. The machine has been designed and
manufactured to ensure an excellent performance and the utmost
comfort and ease of operation in a variety of working conditions. Before
delivery, the machine has been checked at our factory and by our dealer
to make sure it is handed over to you in perfect working order. To
maintain the machine in this condition and ensure problem free
operation, it is essential to follow the routine maintenance instructions
given in this handbook.

1.4 -UNPACKING THE MACHINE

Unpack the machine with the utmost care; avoid carrying out any
operation that could damage it. Once it has been unpacked, check
whether it is damaged. If you notice that it is not in correct working
order, DO NOT use it and inform your dealer.
For packaging and transport purposes, some parts and accessories are
supplied disconnected from the machine. To assemble them, carefully
follow the instructions given in the relevant sections.
Contents of package:
1 Machine.
1 Side brush.
1 Instruction manual
Tool Kit Package: (p/n 9001420):
1x 4mm Allen key
1x 5mm Allen key
2x 10/13 combination wrench
2x M8screw and nut
2x Ignition key
1x Charger LED label
In the case in which one of the above mentioned parts is missing, please
inform your dealer right away.
Take care to keep the packaging materials (bags, cartons, pallets, hooks,
etc) out of the reach of children.
For security reason during the transport, the starting
NOTE
keys are included in the envelop with the documents.

1.5 -CONSUMABLES

Reduction gear: MOVIBLAK
characteristics.
Lead Acid battery: Distilled water.
Fig. 1
Fig. 1
300 lithium grease with

2.1 -PREPARING THE MACHINE FOR OPERATION

2.1.1 -Mounting the side brush
- Switch the brush lift lever (1 Fig.3 ), to OFF.
- Screw out the screw from the side brush shaft.
- Fit the brush on the shaft (Fig. 2/A).
- Screw on the screw and washer.
2.1.2 -Mounting the handlebar
- Withdraw the handlebar fixing screws.
- Lift the handlebar into the work position (1 Fig.2/B ).
- Tighten the handlebar fixing screws.
similar
6
Fig. 2/A
Fig. 2/A
1
Fig. 2/B
Fig. 2/B