Charger Troubleshooting And Error Codes; Important - Tennant S8 Mode D'emploi

Fig.5.3
Fig.5.3

5.4 -CHARGER TROUBLESHOOTING AND ERROR CODES

INDICATION
Steady red LED light
Steady yellow LED light
Steady green LED light
Blinking yellow LED light
Blinking red LED light
Green LED with two blinks
Red LED with two blinks
First normal charging phase
Second normal charging phase
Charging terminated or maintenance phase
ANOMALIES
Either the wrong battery or it is not connected or there is a short circuit in
output
Safety timer exceeded, internal short circuit
INITIAL TEST
Battery charger configured for charging Gel or AGM batteries
Battery charger configured for charging lead-acid traction batteries
5.3 -CHARGER SETTINGS
IMPORTANT: The on-board battery charger is factory set to
accommodate a SEALED (GEL) battery. To use a WET (lead
acid) battery with the machine, the charger's internal dip-
switches must be reconfigured as shown below. Failure to
follow these instructions will result in battery damage.
WET (lead acid) BATTERY DIPSWITCH PANEL
SW1
ON ON
OFF OFF
DIP 1 DIP 2
SEALED (GEL) BATTERY DIPSWITCH CONFIGURATION
SW1
ON ON
OFF OFF
DIP 1 DIP 2
The DIP switches are located behind the round black cover (See
Fig. 5.3).
MEANING
- 11 -
CONFIGURATION
SW2
ON ON
OFF OFF
DIP 1 DIP 2
SW2
ON ON
OFF OFF
DIP 1 DIP 2