Replacing And Adjusting The Belts; Replacing The Drive Belt - Tennant S8 Mode D'emploi

5.8 -REPLACING AND ADJUSTING THE BELTS

To prepare the machine for belt replacement, carry out the fol-
lowing operations:
- remove the top cover and the front bin.
5.8.1 -Replacing the side brush belt
- Remove the right wheel, screw out the screws that fix the bumper
and the lateral right guard and remove them. Once the machine
is disassembled, proceed with the substitution of the broken belt.
- Remove belt pos.1 Fig.7 from pulley pos.2 Fig.7.
- Loosen fixing pin pos.3 Fig.7 and let the hooks of side arm pos.4
Fig.7 come out of the idle toothed ring.
- Remove belt pos.1 Fig.7 from side arm pos.4 Fig.7.
- Replace the belt.
- Hook side arm pos.4 Fig.7 to the idle toothed ring.
- Tighten pin pos.3 Fig.7.
- Using the key cod. 9001451 (not included in the supply) stretch
the belt pos.1 Fig.7/A and put it again on the pulley pos.2 fig.7 /A.

5.8.2 -Replacing the drive belt

- Remove the left wheel, screw out the screws that fix the bumper
and the lateral left guard and remove them. Once the machine
is disassembled, proceed with the substitution of the broken belt.
- Remove the guard pos.1 Fig.8/A .
- Remove belt pos.2 Fig.8/B.
- Insert the new belt on the pulleys pos.3-4 Fig.8/B.
Fig.7/A
1
2
Fig.7
Fig.8/A
Fig.8/B
- 14 -
4
1 3
3
1
2
4