Product Description; Product Components - Fig; Area Of Application - Fig - SOMFY Dexxo Pro 800 io Manuel D'installation

Dexxo Pro io
* For zones 2, 3 and 4, no protection is required if the door
has continuous control or if the danger zone is more than
2.5 m above ground or any other permanent access level.
Deformable cover ensuring
a safety distance of 25 mm
in the compressed position
Figure 3 - Mechanical protection
Figure 4 - Safety distance
5
Profile

2 - PRODUCT DESCRIPTION

2.1 Product components - Fig. 1

Key Number Description
1 1 Motor head
2 1 Motor cover
3 1 Built-in light cover
4 1 Lintel bracket
5 1 Door bracket
6 2 Ceiling bracket
7 2 Motor head bracket
8 1 Manual release cord
9 1 Link arm
10 1 Travel stop
11 4 Chain retainer pad
12 1 Power cable
13 4 Hex. head M8x16 bolt
14 4 Hex. head M8x12 bolt & washer
15 6 HU8 nut
16 2 Shaft
17 2 Circlips
19 4 Self-shaping Ø 4x8 screw
20 2 Special screw for plastic Ø 3.5x12
21a 1 Single part rail
21b 1 Two part rail
21b1 1 Sleeve
21b2 4 Self-shaping Ø 4x8 screw
22 2 HM8 self-locking nut
23a + 24a 2 +1 Bracket + spacer
23b 1 Bracket
25a 1 Keytis 4 io remote control*
25b 2 Keygo io remote control*
26 1 230V E14 40W max
27 1 Antenna
* The model and number of remote controls may vary depending on the pack.

2.2 Area of application - Fig. 2

This motorisation is exclusively intended for the equipement of a garage door
for residential use.
> Types of doors (Fig.2)
A : Projecting up and over door.
B : Sectional door:
- if the door's upper profile is a specific one, use the "sectional door
mounting bracket" ref.: 9009390.
- if the door surface exceeds 10 sq. metres, use the "sectional door
adapter" ref.: 2400873.
C : Sideways opening sliding door: :
- for side wall mounting, use:
- a belt transmission rail
- an "adjustable cranked arm" ref.: 9014481
- for ceiling mounting, use
- an "articulated arm" ref.: 9014482.
D : Swinging door. Use the swinging door kit, ref.: 2400459.
E : Semi and non projecting door. Use
- a high performance transmission rail
- "the semi and non projecting door kit" ref.: 2400458.
Some doors of this type may prove impossible to automate. Contact SOMFY's
technical department.
> Door dimensions (Fig. 3)
For maximum door heights, the motor travel can be optimised:
- By installing the motor head at a 90° angle (Fig. 7-
- By fixing the lintel bracket to the ceiling, behind the lintel itself by up to
200 mm. (Fig. 5- )
- By cutting the link arm to size.
Copyright © 2015 SOMFY ACTIVITES SA. All rights reserved
).