Control Panel Instructions; Light Functions - Tylo Prime+ 1313/C Mode D'emploi

Control panel instructions:

Main current:
Press POWER to turn the sauna ON (AN) or OFF (AUS). If a red light comes
on the sauna is ON. If it is white the sauna is OFF.
Timer functions:
also run your finger up or down the timer to set it.
Timer 2:
Use this function with a pre-setting of up to 24 hours to set the sauna to come on later.
Temperature functions:
1. Press to switch between
2. Press and hold
Pressing once will increase or reduce the setting in one degree intervals. You can also run your finger
over the temperature bar.
The central temperature display shows the actual sauna temperature.
3. Press to set the bench/ leg/ floor heat to ON or OFF. Red waves can be seen in heating mode
and white ones in OFF mode.
:

Light functions

1. Press Inside light to switch it ON or OFF.
2. Note: Outside light ON or OFF will not work with S series models.
Colour therapy functions:
Press the colour therapy light in order to activate coloured light or a colour sequence. The sequence
is shown in detail below:
1. Press – RED
2. Press – RED-GREEN
3. Press – GREEN
Press and hold down
C F
and . C or F will light up to show the required units.
or to set the required temperature.
or in order to set the running time. You can
Page 12