Tylo Prime+ 1313/C Mode D'emploi page 4

Floor panel ( 1): Put the floor panel on a level surface 8–16 cm from the wall panel and no more
Box
than 152 cm away from a 230V socket.
Position the floor panel in such a way that the slot for the glass section is at the front of the sauna.
Note: Put the ceiling, bench valance and bench aside until the corresponding steps.
Left back wall panel and right back wall panel (
• Place the left wall panel section into the back left hand slot of the floor panel.
• The back left rear wall panel section must be held in position while the right rear
wall panel component is located.
• Place the right wall panel section into the back right hand slot of the floor panel.
• Connect the right back wall panel section to the left back wall panel section.
o Lift the right back wall panel and push it into the wall bracket.
• Connect the power connections to the B-1 junction box.
• Fix the cover of the B-1 junction box with 2 Phillips screws.
• Connect the power connections to the B-2 junction box.
• Fix the cover of the B-2 junction box with 2 Phillips screws.
Note – Put the benches aside until the Bench fitting section.
2):
Box
Page 4