Kärcher B 250 R R 100 Mode D'emploi page 19

Operator console
1 Sweeping ON/OFF (side brushes op-
tion or sweeping mechanism for
B 250 RI)
2 Intelligent Key
3 Safety button
4 Programme switch
5 Display
6 Info button
7 Cleaning solution ON/OFF
8 Horn
9 Driving direction switch
Programme switch
1 OFF
Device is switched off
2 Transport run
Driving to the Place of Use.
3 Eco programme
Wet clean the floor (with reduced brush
speed) and vacuum up wastewater
(with reduced suction).
4 Scrubbing suction
Wet clean the floor and vacuum up dirt
water.
5 Heavy programme
Wet clean the floor (with increased
brush contact pressure) and vacuum up
dirt water.
6 Scrubbing
Wet clean the floor and allow the deter-
gent to react.
7 Vacuuming
Suck in the dirt fleet.
8 Polishing
Polishing the floor without the applica-
tion of liquid.
Switch menu
The following functions are switched on
and off via the switch menu:
– Detergent dosing unit (option)
– Working light (option)
– Beacon light (optional)
– Spray suction (option)
– Irrigation of side brushes (option)
The switch menu is available in all pro-
gramme switch positions, except "OFF".
 Press Info button.
The switch menu is displayed.
 Press Info button.
The list of functions available in the ap-
pliance is displayed.
 Turn the info button until the desired
function is highlighted.
 Press the info button to change the
switch condition.
 Turn the info button until "Exit menu" is
displayed.
 Press Info button.
Symbols on the machine
Lift the squeegee blade.
Lower the squeegee blade.
Drain for waste water
Drain for fresh water
Automatic fresh water tank filling
system (Auto Fill-In, option)
Locked
Unlocked
Remove the coarse dirt bin
Symbols on the charger
16 A 16 A 16 A
DANGER
Risk of fire!
If plugged into an unsuitable socket or in
the event of poor electrical contact between
3
-
EN
the plug and the socket, the charger plug
and the socket used may get very hot.
Before plugging in the mains plug, make
sure that the socket is approved for a cur-
rent of 16 A and that it is in a technically
sound condition.
Make sure that the mains plugs is clean
and in a good condition.
Before Startup
Batteries
Please observe the following warning notes
when handling batteries:
Observe the directions on the bat-
tery, in the instructions for use and
in the vehicle operating instructions
Wear eye protection
Keep children away from acid and
batteries
Danger of explosion
Fire, sparks, naked flames and
smoking must be strictly avoided
Danger of chemical burns
First aid
Warning note
Disposal
Do not throw the battery into the
regular waste
DANGER
Risk of explosion! Do not put tools or similar
on the battery, i.e. on the terminal poles
and cell connectors.
WARNING
Risk of injury! Ensure that wounds never
come into contact with lead. Always clean
your hands after working on batteries.
Insert batteries and connect
The BAT package model contains built-in
batteries.
 The steering position should point to-
wards the front.
 Swivel the seat to the front.
 Remove screw of seat stopper.
1 Plug for seat contact switch
19