Porsche Home Energy Manager 9Y0.915.686 Mode D'emploi page 19

Option Explanation
e
Using an end device that
has an Internet connection,
scan in the QR code dis-
played or enter the dis-
played URL manually in the
browser.
e
On the website for the Porsche ID account, enter
the login data (Porsche ID, password).
7. Home setup: Setting grid phases
Set the number of available grid phases for the house
connection.
Option Explanation
Single phase Only one phase is used.
Shared Single-phase three-wire network
phases
Three-phase 3 phases are used.
8. Home setup: Adjusting current sensors
Select and assign current sensors.
Column Explanation
Active Connection position
is active
Connection position Connection position
on the device
Phase Selected phase of
the house connection
Current sensor Installed current sen-
sor
Current limit [A] Set current limit
Live analysis Visibility in the live
analysis
9. Home setup: Adjusting power sources
Assign current sensors to the various power sources
(house connection, photovoltaics, etc.) and select the
type of connection if a photovoltaic system is availa-
ble.
House connection
Only the current sensors created in step 8 are dis-
played.
1. Assign a current sensor to a phase.
2. If necessary, apply additional current sensors in
step 8.
Photovoltaic system
If there is a photovoltaic system at the place of use,
information on the type of connection and the feed-
in compensation is required for energy management.
1. Activate function.
2. Select the connection type of the photovoltaic
system:
Option Explanation
On the load The system is connected to the
side power grid after the house con-
nection.
Excess power from the photovol-
taic system flows via the house
connection to the mains (the
electricity measured by the en-
ergy manager on the house con-
nection can be negative in this
case).
On the power The system is connected to the
grid side power grid before the house con-
nection. The power from the pho-
tovoltaic system is fed directly
into the power grid.
Example Shows the two types of configu-
ration in one example.
Phases and current sensors
If there is a photovoltaic system, the phases can be
selected here and the current sensors assigned.
1. Choose the number of phases.
2. Assign phases to the current sensors.
10. Home setup: Set power consumers
Create and configure power consumers.
17