Connections For Mma Welding - Magmaweld monoTIG 220ip Mode D'emploi

20 Installation

2.6 Connections for MMA Welding

EN
Check for the correct mains voltage before connecting the machine to the mains.
When plugging the power plug into the outlet, make sure that the power switch is set to "0" in
• Start the machine with the on/off switch and check whether the LEDs are on and the cooling fan is working.
the turned-off position.
• Connect the electrode clamp cable plug (c) and the grounding clamp cable plug (a) to the welding and ground
cable sockets according to the electrode to be used and the polarity recommended by the electrode manufacturer.
• To improve the welding quality, firmly connect the grounding pliers (b) to the workpiece as close as possible to
the welding area.
b
USER MANUAL
monoTIG 220ip / 220ipw / 220ip AC-DC / 220ipw AC-DC
Electrode
2.0
Diameter "mm"
2.5
3.25
4.0
c
a
Rutile Alkaline
Recommended Welding Current
40-60 A -
60-90 A 60-90 A
100-140 A 100-130 A
140-180 A 140-180 A
www.magmaweld.com
Cellulosic
-
60-100 A
70-130 A
120-170 A