Connections For Mma Welding - Magmaweld MONOTIG 220ip Manuel D'utilisation

18 Installation
2.6 Connections for (MMA) Welding
EN
Check for the correct mains voltage before connecting the machine to the mains.
When plugging the power plug into the outlet, make sure that the power switch is set to "0" in the turned-off position.
• Start the machine with the on/off switch and check whether the LEDs are on and the cooling fan is working.
• Connect the electrode clamp cable plug (c) and the grounding clamp cable plug (a) to the welding and ground cable sockets according to the
electrode to be used and the polarity recommended by the electrode manufacturer.
• To improve the welding quality, firmly connect the grounding pliers (b) to the workpiece as close as possible to the welding area.
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Covered Recommended Welding Current
"mm" Rutile Alkaline
2.0 40-60 A
2.5 60-90 A
3.25 100-140 A 100-130 A
4.0 140-180 A 140-180 A
MONOTIG 220ip - MONOTIG 220ip AC/DC
Cellulosic
- -
60-90 A 60-100 A
70-130 A
120-170 A
www.magmaweld.com