Gas Connections; Trigger And Pedal System Socket Connections - Magmaweld monoTIG 220ip Mode D'emploi

18 Installation
• Secure the argon gas cylinder (a) with a chain.

2.5.2 Gas Connections

EN
• Use safe high quality regulators (b) and heaters approved by the standards to work safely and achieve the best
results.
• Keep the gas cylinder valve (c) open for a while, so that possible sediment and particles are discharged.
• Connect the gas regulator to the gas cylinder, making sure that the thread on the gas outlet of the gas cylinder
and the nut of the regulator overlap.
• Connect one end of the cylinder hose (d) to the gas regulator and the other end to the gas inlet at the rear of the
machine and turn on the gas cylinder valve.
• Adjust the flow rate with the flow regulating valve (e).
• Make sure the connections are free of leakages.
c
a

2.5.3 Trigger and Pedal System Socket Connections

(1) Soldering direction has been taken as the reference.
• TIG Torch Connection; the trigger should be connected to the control socket with the terminals 1-2-3-4-5 as
shown.
(2) Soldering direction has been taken as the reference.
• Adjustable Pedal Connection; It should be secured to the pedal socket with the ends 3-4-5-6.
USER MANUAL
b
e
d
monoTIG 220ip / 220ipw / 220ip AC-DC / 220ipw AC-DC
Electrode Nozzle
Diameter Diameter
1.0 6.3
(mm) (mm)
1.6 9.5
Welding
Current Gas Flow
30-70 6-8
(ADC) (lt/sec)
30-150 6-8
www.magmaweld.com