Gas Connections; Trigger And Pedal System Socket Connections - Magmaweld MONOTIG 220ip Manuel D'utilisation

16 Installation

2.5.2 Gas Connections

EN
• Secure the argon gas cylinder (a) with a chain.
• Use safe high quality regulators (b) and heaters approved by the standards to work safely and achieve the best results.
• Keep the gas cylinder valve (c) open for a while, so that possible sediment and particles are discharged.
• Connect the gas regulator to the gas cylinder, making sure that the thread on the gas outlet of the gas cylinder and the nut of the regulator overlap.
• Connect one end of the cylinder hose (d) to the gas regulator and the other end to the gas inlet at the rear of the machine and turn on the gas
cylinder valve.
• Adjust the flow rate with the flow regulating valve (e).
• Make sure the connections are free of leakages.

2.5.3 Trigger and Pedal System Socket Connections

(1) Soldering direction has been taken as the reference.
• TIG Torch Connection; the trigger should be connected to the control socket with the terminals 1-2-3-4-5 as shown.
(2) Soldering direction has been taken as the reference.
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Electrode Nozzle
Diameter Diameter
(mm) (mm)
1.0 6.3
1.6 9.5
MONOTIG 220ip - MONOTIG 220ip AC/DC
Welding
Current Gas Flow
(ADC) (lt/sec)
30-70 6-8
30-150 6-8
www.magmaweld.com