Catalyst Probe Installation/ Replacement - Napoleon HIGH COUNTRY NZ3000H Instructions D'installation Et D'utilisation

28

6.3.5 CATALYST PROBE INSTALLATION/ REPLACEMENT

EN
IT IS IMPORTANT TO INSTALL THE REPLACEMENT CATALYST PROBE PRIOR TO FRAMING IN
THE UNIT COMPLETELY. IF WALL MOUNTING THE CATALYST MONITOR, PROVISIONS MUST BE
MADE IN ORDER TO MAKE FISHING THE WIRE THROUGH THE WALL EASIER IN THE EVENT OF
REPLACEMENT (I.E. CONDUIT)
Before installing catalyst monitor, determine how it will be mounted. The options for mounting are:
1. Wall mounted left of appliance
2. Wall mounted right of appliance
3. Hearth mounted
Remove the top and bottom trim (if hearth mounted) off of the unit.
TOP TRIM REMOVAL
A
Loosen set screw, unthread and remove
the knob on the right side of the
C
Pull decorative trim away from
BOTTOM TRIM REMOVAL
A
Remove the screws on the left & right
W415-1517 / A / 09.02.16
decorative trim.
appliance.
side of the decorative trim.
B
Unscrew the four retaining screws.
B
Pull decorative trim away from unit.
X4