Napoleon HIGH COUNTRY NZ3000H Instructions D'installation Et D'utilisation page 45

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4
Move perforated catalyst shield up
and over shoulder bolts.
6
Remove perforated catalyst shield.
8
Slide the catalyst forward and out. The steel
tabs are friction held and will separate from the
catalyst when pulled out.
10
Reinstall perforated catalyst shield in reverse.
Ensure basket rests on shoulder bolts from
STEP 2. Reinstall fi bre baffl e.
5
Pivot the perforated catalyst shield forwards
until it is facing downwards .
7
Grab the steel tabs located on either side of
the catalyst.
9
Holding the steel tabs located on either side of
the catalyst, slide the new catalyst into the cav-
ity. TIP: Securing tabs with masking tape may
aid installation.
45
EN
W415-1517 / A / 09.02.16

Publicité

Table des Matières
loading

Table des Matières