Face Plate Installation; Template Removal; Faceplate, Hinge, Ash Lip And Air Control Arm Installation - Napoleon HIGH COUNTRY NZ3000H Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6.3

FACE PLATE INSTALLATION

6.3.1 TEMPLATE REMOVAL

Template

6.3.2 FACEPLATE, HINGE, ASH LIP AND AIR CONTROL ARM INSTALLATION

PRIOR TO INSTALLATION, ENSURE CATALYST PROBE IS INSTALLED. SEE "CATALYST
NOTE: The FPWI3-H faceplate is shipped with the
upper and lower grilles assembled. Remove both
grilles before proceeding.
A.
Assemble the air control arm by removing
the 2nd screw, rotating the arm in line and
re-installing the screw.
B.
Install the ash lip.
PROBE INSTALLATION/REPLACEMENT" SECTION FOR DETAILS.
1
AIR
CONTROL
3
SLOT
FRONT ARCHED
PANEL
25
Remove the screws and
template, discard only the
template once all the facing
material has been installed.
Retain the screws for installing
the faceplate.
2
ASH LIP
X 3
X 9
W415-1517 / A / 09.02.16
EN

Publicité

Table des Matières
loading

Table des Matières